If anyone is reading, listening, or just in the general area and feeling philanthropic, I need help. For the most part, I am quiet self-sufficient. If I want to learn how to do something, I learned a long time ago, the instructional information is out there somewhere and if I look long enough and hard enough, put the time in actually reading the material, I can figure most things out. So why, please tell me why, am I not able to scan in my scrap projects? If you think I’m sounding a bit desparate…you would be right. I am also totally, completely and utterly frustrated! And, yes, I am whining. I understand scanning the right and left side of my page, dragging and dropping into layers in Photoshop, altering opacity of one layer in order to line up the two side, restoring 100% opacity and flattening the image. Sound like I know what I’m doing? Yes, but no. I’ve completed all the steps, but for the life of me, NOTHING will line up.
So I resorted to taking pictures of my pages. No luck there either. I’m at work during the daylight hours thus no good light for my photos! Add to the mix that I have a virus that causes episodes of vertigo and a photographer’s nightmare is born. Either I was taking crooked photos or I was seeing crooked. Beats me. Just couldn’t get a straight shot to save my life. Wait a minute…could it be that my pages WERE lining up when scanned only I saw them sideways? Nonetheless, I want to post some pages, but they are gonna have to wait until someone comes to my rescue or my world stops spinning! Both would be nice.
Sidenote: I was prescribed Meclizine for the dizziness.
Directions state: “Take 1 tablet 4 times a day as needed for dizziness.”
Warning states: “May cause dizziness”…….huh????